post01

fotoboiler diameter 2 9

Purchased equipment: fotoboiler diameter 2 9
Location: WUXI China
Telephone: +86 13861509127
E-mail: [email protected]
Contact us for more details about our boilers, solutions and services.

High quality aluminum silicate fiber is used with fire clay insulation, to control the boiler body temperature below 45℃ and reduce heat lost.Sufficient steam storage room and heating area to generate high quality steam and high thermal power.Condenser is added to recycle the waste heat of the exhausted smoke to increase feeding water’s temperature and reduce flue gas emission temperature and increase the thermal efficiency over 98% and save operating cost.

Environmental protection

Big combustion chamber equipped with Low emission combustion burner effectively reduce the NOx to 30mg/m3. Smoke duct and smoke outlet use internal insulation to reduce operating noise.

Combustion chamber uses full membrane water cooling wall structure and pressurized combustion without smoke mixture.

Energy conservation

Good quality alumina silicate fiber and fire clay insulation material are used and the boiler body temperature is controlled below 45℃ and greatly heat loss is reduced. Combustion chamber is designed with narrow distance tube membrane water cooling wall which has good air proof to reduce heat lost and increase boiler thermal efficiency. Internal inspection holes uses high-alumina refractory and manhole cover seal devices, solving superheat problem in this part caused by using refractory bricks.

CNC manufacturing technology

The key processing technologies such as steel plate blanking, circling, drum and tube plate drilling adopt advanced CNC machining to reduce the assembly stress and prolong the service life of the boiler.

Steel tube cutting, thread tube pressing and convection tube processing all adopt advanced CNC technology.

Automatic production line.

Leave a Comment

pro_first

Standard Pitch Diameter Chart Plug Thread Gag

Standard Pitch Diameter Chart 17 PRECISION GAGES FOR QUALITY ASSURANCE Ring Thread Gages and Setting Plugs NOMINAL SIZE X TOL. 9/2/2000 12:27:58 PM

SIZE:9-1/8"DIAX1-1/2"H?

DIAdiameter,;''inch ,;X;Hhigh,.SIZE:9-1/8" DIA X 1-1/2" H

Wire Gauge vs. Diameter - Ted Pella, In

AWG gauge : Conductor Diameter Inches: Conductor Diameter mm: Ohms per 1000 ft. Ohms per km: Maximum amps for chassis wiring: OOOO: 0.46000: 11.68400: 0.0490: 0

EUROPEAN PHARMACOPOEIA 5 - uspbpep.c

EUROPEAN PHARMACOPOEIA 5.0 2.9.1. Disintegration of tablets and capsules 2.9. PHARMACEUTICAL TECHNICAL PROCEDURES 01/2005:20901 2.9.1. DISINTEGRATION OF TABLETS Each disc is pierced by 5 holes 2 mm in diameter, 1 in the centre and the other 4 spaced equally on a circle of radius 6 mm from the centre of the disc. On the lateral

Diameter/Circumference Conversion Calculator - Pyramid I

Please enter the dimensions you wish to convert. Inside Circumference. Inside Circumference

Diameter / Decimal / Metric Chart for Small Diameter

4.8 4 or 5 2 5.8 5 2 8.8 8 5 A325, A449 9.8 9 5+ A193, B7 and B16 10.9 10 or 12 8 A490, A354, Grade 8D 12.9 10 or 12 A540, B21 through B24 Common DIN Numbers for Metric Fasteners DIN Hex Cap Screws 931 Coarse thread pitch partially threaded (specify grade) 933 Coarse thread pitch fully threaded (specify grade)

Nominal Pipe Size - Wikiped

Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. "Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only